Digi TransPort - Page 301

Configure Advanced interfaces settings
Digi TransPort User Guide 301
ppp n natip Valid IP address
a.b.c.d
NAT Source IP address a.b.c.d
ppp n ipsec 0,1
0=Off
1=On
Enable IPsec on this interface
ppp n Keep Security Associations (SAs)
when this PPP interface is
disconnected
ppp n ipsecent Default
PPP
Ethernet
Use interface x,y for the source
address of IPsec packets
ppp n ipsecadd Valid interface
number
Use interface x,y for the source
address of IPsec packets
ppp n firewall OFF, ON Enable the firewall on this interface
ppp n qos OFF, ON Enable QoS on this interface
ppp n use_modem
ppp n cdma_backoff 0,1
Default: 1
ppp n ndis OFF, ON
ppp nocfg 0,1,2,3 Remote management access
0=No restrictions
1=Disable management
2=Disable return RST
3=Disable management and return
RST
ppp n igmp OFF, ON Enable IGMP
ppp n ifspeed 64000 bps None. CLI command only. The ppp
command allows configuring the
interface speed for reporting in
SNMP.
ppp n norxrst OFF, ON
Entity Instance Parameter Values Equivalent Web Parameter