Configure Advanced interfaces settings
Digi TransPort User Guide 311
Related CLI commands
Entity Instance Parameter Values Equivalent Web Parameter
ppp n metric 0-255 Metric
ppp n settledly 0-200 Allow this PPP interface to settle for s
seconds after the connection has come
up
ppp n aodion 0-2
0=disabled
1=enabled
2=On and
return to service
immediately
Enable “Always On” mode of this
interface, On, On and return to service
immediately
ppp n autoassert 0,1, 3
0=no autoassert
1=autoassert
with route up
delay
2=autoassert
with no route
up delay
ppp n immoos ON, OFF Put this interface “Out of Service” when
an always-on connection attempt fails
ppp n rdoosdly ON, OFF remote disconnect
ppp n aodi_dly 0-2147483647 Attempt to reconnect after s seconds
ppp n aodi_dly2 0-2147483647 If a PPP interface that would be
inhibited by this PPP is connected,
attempt to re-connect after s seconds
ppp n pwr_dly 0-2147483647 Wait s seconds after power-up before
activating this interface
ppp n minup 0-2147483647 Keep this interface up for at least s
seconds
ppp n multi OFF, ON Enable Multilink PPP on this interface
ppp n netip Valid IP address
a.b.c.d
Add a route to a.b.c.d if the peer’s IP
address is not negotiated
ppp n rbcast OFF, ON Forward IP broadcasts over this
interface if this interface is on the same
IP network as an Ethernet interface
ppp n OFF, ON Send LCP echo request packet to the
remote peer
To Next Page
Loading...
