Configure Advanced interfaces settings
Digi TransPort User Guide 312
ppp n echo 0-2147483648 Send LCP echo requests every s
seconds
ppp n echodropcnt 0-2147483648 Disconnect the link after n failed echo
requests
ppp n Generate Heartbeats on this interface
ppp n hrtbeatip Valid IP address
a.b.c.d
Send Heartbeat messages to IP
address a.b.c.d every h hrs, m mins, s
secs
ppp n hrtbeatint 0-2147483648 Send Heartbeat messages to IP
address a.b.c.d every h hrs, m mins, s
secs
ppp n hbipent Blank, PPP, ETH
Blank is default
Use interface x,y for the source IP
address
ppp n hbipadd Valid interface
number
0-2147483648
Use interface x,y for the source IP
address
ppp n hbiproute OFF, ON Select transmit interface using the
routing table
ppp n hbimsi OFF, ON Include IMSI information in the
Heartbeat message
ppp n hbgps OFF, ON Include GPS information in the
Heartbeat message
ppp n OFF, ON Generate Ping packets on this interface
ppp n pingsiz 0-2147483648 Send n byte pings to IP host a.b.c.d
every h hrs, m mins, s secs
ppp n pingip Valid IP address
a.b.c.d
Send n byte ping to IP host a.b.c.d
every h hrs, m mins, s secs
ppp n pingint 0-2147483648 Send n byte ping to IP host a.b.c.d
every h hrs, m mins, s secs
ppp n pingint2 0-2147483648 Send pings every h hrs, m mins, s
seconds if ping responses are not
being received
ppp n pingip2 Valid IP address
a.b.c.d
Switch to sending pings to IP host
a.b.c.d after n failures
ppp n ip2count 0-2147483648 Switch to sending pings to IP host
a.b.c.d after n failures
ppp n pingresp 0-2147483648 Ping responses are expected within s
seconds
Entity Instance Parameter Values Equivalent Web Parameter