EasyManua.ls Logo

Digi TransPort - Page 313

Digi TransPort
813 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configure Advanced interfaces settings
Digi TransPort User Guide 313
ppp n pingis OFF, ON Only send Pings when this interface is
“In Service
ppp n ping2cont OFF, ON New connections to resume with
previous Ping interval
ppp n pingdeact 0-2147483648 Reset the link if no response is received
within s seconds
ppp n pingfreth0 OFF, ON Use ETH 0 IP address as the source IP
address
ppp n pingresetint OFF, ON Defer sending pings if IP traffic is being
received
ppp n OFF, ON Limit the data transmitted over this
interface
ppp n dlwarnkb 0-2147483647 Issue a warning event after n XBytes
ppp n dlstopkb 0-2147483647 Stop Data from being transmitted after
n XBytes
ppp n dlrstday 0-255 Reset the data limit on the n day of the
month
ppp n When the link disconnects, indicate
that the connection failed if no IP
packets were received
ppp n sscnt 0-2147483648 Reset this interface if n packets are
transmitted and the connection has
been up for at least s seconds
ppp n sssecs 0-2147483648 Reset this interface if n packets are
transmitted and the connection has
been up for at least s seconds
ppp n lscnt 0-2147483648 Reboot the router after n consecutive
resets
ppp n rebootfails 0-2147483648 Reboot the router after n consecutive
connection failures
ppp n radius OFF, ON Use RADIUS for authentication when
acting as a server
ppp n radiuscfg Use RADIUS instance
ppp n acttries 0-255 Allow this PPP interface to attempt to
connect n times before allowing other
PPP interfaces inhibited by this
interface to connect
Entity Instance Parameter Values Equivalent Web Parameter

Table of Contents

Related product manuals