Digi TransPort - DSCP Mappings Parameters

DSCP Mappings parameters
Digi TransPort User Guide 485
DSCP Mappings parameters
The Configuration > Network > QoS > DSCP Mappings page contains parameters to configure
DSCP operation. Each DSCP value must be mapped to a queue. These mappings are set up using
this page.
Default
Selects the default queue. When this is changed, any DSCP codes that are set to use the
default will have their queue number changed.
DSCP
A list of valid DSCP codes with an associated drop-down list box to the right.
Queue
Each of the DSCP codes in the left-hand column has a queue associated with it. To change the
value from what is shown, select the desired value from the drop-down list.
Related CLI commands
Examples
• To display a DSCP mapping from the command line, type the following:
dscp <code> ?
Where <code> is a valid DSCP code from 0 to 63, or 64 (see note below).
•To change the value of a parameter, use the following command:
dscp <code> q <value>
Where <code> is a valid DSCP code and <value> is from 0 to 9.
• To set the default mapping value, enter the command:
dscp 64 q <value>
Where <value> is the default queue number required and has a value from 0 to 9.
Note DSCP code 64 is not actually a valid code, but is used to set up the default priority.
Entity Instance Parameter Values Equivalent Web Parameter
dscp n q 0-63
Default 4
Queue