Configure Systems Network Architecture over IP (SNAIP)
Digi TransPort User Guide 505
Include MAC Exclusivity Capability
On or Off. Set this parameter to On to include the MAC exclusivity value in the capabilities
exchange message.
MAC Exclusivity Value
See above.
Ignore unsolicited response frames
When enabled, the router ignores unsolicited response frames.
Wait for Contact before progressing to CONNECT PENDING state
During the DLSw negotiation phase and when XID messages are being exchanged, this
parameter controls which end sends the CONTACT message. Normally this would be off in
which case this router would send the CONTACT message, but if this parameter is set, we
would not send this message, but instead wait for it to be sent to us before progressing in the
DLSw state machine.
Make immediate connection attempts before backing off
The number of successive connection attempts before backing off for the number of seconds
(default 30) defined in the Backoff for x seconds... parameter. This backoff might be
necessary when a server is behind a firewalls that detects too many successive connection
attempts in a certain time frame.
Backoff for x seconds before attempting to connect again
When backing off because of too many failed consecutive connection attempts, this
parameter defines the time, in seconds, the router should remain idle before attempting
another connection.
To Next Page
Loading...
