Configure X.25 parameters
Digi TransPort User Guide 541
Stopping and starting PADs
PAD instances can be stopped and started using the following CLI commands:
• stoppads: Stops all PAD instances from accepting and performing any PAD commands.
• gopads: Resumes processing of PAD commands.
The stoppads and gopads commands can have the PAD number specified in the syntax to stop
and start individual PAD instances.
For example:
• To stop PAD 1 from processing PAD commands:
stoppads 1
•To re-enable PAD 1:
gopads 1
To Next Page
Loading...
