Digi TransPort - Page 548

Configure X.25 parameters
Digi TransPort User Guide 548
20 Echo Mask
Defines characters that are not echoed when echo mode has been enabled using parameter
2.
Combinations of the above sets of characters are possible by adding the respective values
together.
21 Parity Treatment
Determines whether parity generation/checking is used.
22 Page Wait
Determines how many line feeds are sent to the terminal before output is halted on a page
wait condition. In other words, it defines the page length for paged mode output. A page wait
condition is cleared when the PAD receives a character from the terminal
Related CLI commands
The X.3 PAD parameters can be edited from the command line using the set command,
described in X.28 commands on page 552 .
Option Description
0 No echo mask (all characters are echoed)
1CR
2LF
4VT, HT or FF
8BEL, BS
16 ESC,ENQ
32 ACK,NAK,STX,SOH,EOT,ETB,ETX
64 No echo of characters set by parameters 16, 17 & 18
128 No echo of characters set by parameters 16, 17 & 18
Option Description
0 No parity generation or checking
1Parity checking on
2Parity generation on
3 Parity checking and generation on
Option Description
0 Page wait feature disabled
1 Number of line feeds sent before halting output