Digi TransPort - Page 552

Configure X.25 parameters
Digi TransPort User Guide 552
X.28 commands
Once an X.25 session layer has been established the router switches to PAD mode. In this mode,
operation of the PAD is controlled using the standard X.28 PAD commands listed in the following
table:
Command Description
CALL Make an X.25 call
CLR Clear an X.25 call
ICLR Invitation to CLR
INPAR? List X.3 parameters of specified PAD instance
INPROF Load or save specified PAD profile
INSET Set X.3 parameters of specified PAD instance
INT Send Interrupt packet
LOG Logoff and disconnect
PAR? List local X.3 parameters
PROF Load or save PAD profile
RESET Send reset packet
RPAR? List remote X.3 parameters
RSET Set remote X.3 parameters
SET Set local X.3 parameters
STAT Display channel status