Date and Time parameters
Digi TransPort User Guide 614
Autoset Date and Time parameters
Do not auto-set the system time
This is the system default, and this radio button will appear filled in when the router is new
unless a different default configuration has been supplied. Click this radio button to close the
SNTP or NTP configuration pages.
Auto-set the system time
Selecting this radio button expands the page to include the SNTP settings, described below.
SNTP server
The hostname or IP address of the desired SNTP server.
Check on Power-up
This checkbox, when checked, causes the router to attempt to connect to the SNTP server
every time it boots.
Update every h hours
The interval, in hours, the router should wait between updating the system clock.
Randomly between s1 and s2 seconds
It is possible to use a random update interval rather than a fixed interval. There are two text-
entry boxes for this purpose. Enter the minimum interval into the left-hand box, and the
maximum desired interval into the right-hand box. Selecting the random update clears the
fixed interval.
Offset from GMT
This parameter should be set to + or - the number of hours the router’s time should be ahead
or behind Greenwich Mean Time.
Update for Daylight Saving Time.
When checked, this checkbox causes the following parameters to appear, the router uses
those settings to automatically adjust the system time to ensure that local daylight saving is
used.
To Next Page
Loading...
