Digi TransPort - Page 696

GPS parameters
Digi TransPort User Guide 696
Send GPS messages to IP address a.b.c.d
The IP address to which the GPS data should be sent.
Port n
The required TCP/UDP port number that the GPS data should be sent to is specified here.
Every n interval(s)
Controls how often the GPS data is transmitted to the specified host.
•A value of 1 cause collected GPS data to be transmitted each time a UTC and local date/
time data (ZDA) message is received from the GPS receiver module.
•A value of 2 causes every second message to be sent and so on.
For this feature to work over a TCP/IP connection, the ZDA message must be enabled.
Use TCP / UDP
The protocol to use for sending the messages.
Prefix the message with t
A text string that should precede the NMEA data, if desired.
Suffix the message with t
A text string that should follow the NMEA data, if desired.
IP Connection 2
Send GPS messages to IP address a.b.c.d
The IP address to which the GPS data should be sent.
Port n
The required TCP/UDP port number to which the GPS data should be sent.
Every n interval(s)
How often the GPS data is transmitted to the specified host.
•A value of 1 causes collected GPS data to be transmitted each time a UTC and local date/
time data (ZDA) message is received from the GPS receiver module.
•A value of 2 causes every second message to be sent and so on.
For this feature to work over a TCP/IP connection, the ZDA message must be enabled.
Use TCP / UDP
The protocol to use for sending the messages.
Prefix the message with t
A text string that should precede the NMEA data, if desired.
Suffix the message with t
A text string that should follow the NMEA data, if desired.