View network interface status
Digi TransPort User Guide 732
Protocol
The protocol that created the route. This setting can be one of the following:
Idx
Used for static routes only. The index of the configured static route.
Interface
The interface over which the IP packet will be routed when the route is used.
Status
The current status of the route. This setting can be one of the following:
Related CLI commands
Local The route is for a network connected directly to the router.
Remote The route is for a remote network accessed via a PPP
connection.
Static The route is a static route.
Static/RIP The route is a static route that has been updated by RIP.
RIP The route is a RIP route.
IBGP The route is an interior BGP route.
EBGP The route is an exterior BGP route.
OSPF The route is an OSPF route.
UP The route is up and can be used for routing.
DOWN The interface that the route uses is currently down. The interface
can be activated if the route is required.
OOS The interface that the route uses is currently “Out of Service”.
Command Options Equivalent Web Parameter
route print Displays the IPv4 routing table.
route printsrc Displays the IPv4 routing table with the src addr information.
To Next Page
Loading...
