Save configuration settings to a file
Digi TransPort User Guide 800
Save configuration settings to a file
Once you have configured the router, save your chosen settings to non-volatile memory to avoid
losing them when the power is removed.
Save current configuration to Config n
Sets the configuration file to which the current configuration will be saved when the Save
button is clicked. There are two options: profile 0 and profile 1. The configuration profile
used when the router powers up is indicated in the selection box. The default power-up
profile is profile 0.
Save all configuration
The Save All button saves the router’s entire configuration.
• The current configuration parameters are saved to config.da0 or config.da1 file**.
• The ciphered versions of the passwords are saved to the pwds.da0 or pwds.da1 file**.
• The Firewall configuration is saved to the fw.txt file.
• The serial port configuration is saved to profile 0 of the sregs.dat file.
• The PAD parameters on all the PADs are saved to profile 0 of the x3prof file
Related CLI commands
** The default power up profile is profile 0. *.da0=profile 0, *.da1=profile 1.
Parameter Options Equivalent Web Parameter
config save Save current configuration to Config n
saveall n/a Save all configuration
To Next Page
Loading...
