Digi TransPort - Page 82

Signal strength indicators
Digi TransPort User Guide 82
RJ45 to 9-Pin straight through cable
This cable is normally used to connect a V.24 asynchronous terminal, such as a PC to a Digi
router.
25-Pin to 25-Pin crossover cable
This cable is normally used to connect the router to a V.24 leased line.
Note Frame Ground is optional.
RJ45-Digi Side DB 9
Signal Pin # (DCE) Pin # (DTE) Signal
RTS 17RTS
DTR 24DTR
RxD 32RxD
GND 55GND
TxD 63TxD
DCD 71DCD
CTS 88CTS
DB 25-Digi Side DB 25
Signal Pin # (DCE) Pin # (DTE) Signal
Frame Ground (Case) Shield Shield Frame Ground (Case)
TxD 23RxD
RxD 32TxD
RTS 45CTS
CTS 54RTS
GND 77GND
DCD 8 20 DTR
RxC 1724ETC
DTR 20 8 DCD
ETC 2417RxC