[6]
After connecting peripheral devices such as monitors and a mouse to the module, power up the
module by connecting DC12V adaptor/ power cable to the power jack on the rear panel. The boot
logo will display. Please wait until the boot process completes.
When the system is up, the password change window is displayed. The user must set the password to
a minimum of 8 characters with at least 3 combinations of uppercase letters, lower case letters, numbers
and special characters. Acceptable special characters are 『~ ‘ ! $ ^ ( ) _ - | { } [ ] ; . ? /』. To login, right-
click anywhere on the screen and enter the username and password in the popup screen. There is only
one Administrator Account configurable in the module. It is assigned with an unchangeable User ID
marked as ‘admin’. The administrator account has full access to the module and its configurable
parameters and can also create new users and assign rights to the new user accounts.
If the module is set as AUTO LOGIN, the login process is not necessary.
1) It may take a few minutes to start up the system after turning on the power, in case the
user sets the network configuration as DHCP mode but under the situation that there is
no DHCP server in the network or the network is not connected.
2) The mouse is included. In case you need to replace it, it is highly recommended to
choose well-known major brands such as DELL, MICROSOFT, LOGITECH, or
1) Contact DW’s technical support to reset your password.
2) Refer to “Section 4.1.2 User” for AUTO LOGIN and AUTO LOGOFF.
To turn off the power, click the exit button [ ] the toolbar, then select SHUTDOWN in the Exit
screen.
Input the password and click the OK button to shut down the system. Click the YES button to confirm
shutdown.
Input passwords using the virtual keyboard.
To Next Page
Loading...