4.2.2. AUDIO
Select an audio input and output during Live display and match it to a specific channel. The
number of audio channels may differ depending on the DVR model. Users can hear audio sound
under both Live display and playback mode depending on the system setting.
• AUDIO: Activate and designate camera channels for audio input capture. To hear audio, an
audio output device must be connected to the DVR or be viewed using the Web Viewer.
• LIVE: Activate for live audio output when listening through a connected speaker. An audio
output device must be connected to hear audio from the DVR. Full screen the channel to
hear video while viewing in Live Mode.
• USE 2-WAY AUDIO: Enable to allow two-way audio for connected devices.
4.2.3. PTZ
Full control of the PTZ camera is available on this menu. Please refer to Section 3.2.4 PTZ
Operation for more information on running a PTZ camera.
Protocol
Select the proper protocol of the connected PTZ camera. If the PTZ camera is connected by
UTC-type protocol, the baud rate and address setup are disabled.
Baud Rate
Select the baud rate level from 2,400bps up to 57,600bps. (Not supported in UTC type
protocol).
To Next Page
Loading...
