Motion detection area and sensitivity should be set, properly, in consideration of the
actual motion that happened at the site.
Notify
Enable motion notification via a buzzer sound and/or a pop-up warning.
Copy Setting
To apply the settings to all cameras connected to the DVR, click on the Copy Settings
button:
1. Select the original channel that the setting is being copied from.
2. Select the property(s) to copy.
3. Select the target channel(s) to apply the setting.
4. Click OK to apply the setting to all the other selected channel(s).
4.3.3. Extra Alarm
Setup alarms for more DVR abnormalities such as smart HDD check, video loss, recording
failure, power failure and disk full.
S.M.A.R.T.
Trigger an alarm signal when HDD is about to be out of operation. Please refer to “4.1.4
HDD” to check the HDD status.
Video Loss
To Next Page
Loading...
