expression pedal. Once the External Expression pedal is connected, the assignment procedure to be followed is listed below.
Linking a Parameter to a Modifier
Note- Any changes made during this procedure must be stored with the program to be effective when recalled later.
To link a Parameter to a modifier, please do the following:
1. Scroll to the parameter you would like to link to a modifier (ie: Delay feedback). See page 26 if your not sure how to scroll
through a module’s parameters.
2. Press <Assign>, the display will appear something like:
If the currently selected parameter is not already linked, you are taken to the next available link in this menu.
3. Turn the <1> knob to turn the link for that parameter on. The display will look something like this:
4. Use the <2> knob to scroll through the different modifiers that can be linked to the Parameter you want assigned. The options
are:
MIDI CC’s (CC): 0-127 & ChP (aftertouch)
Real Time modifiers (RT): LF1, LF2, dY1, & dy2
Expression Pedal (Pdl 1) Exp 1, Exp 2 and Exp 3
Footswitch: (FS#) F1-F10
NOTE: The MUTE and THRU effect types do not have any parameters to connect to, so they will not appear in the
parameter list.
5. Use the <3> knob to select the minimum parameter value you want when the controller is in the maximum position.
6. Use the <4> knob to select the maximum parameter value you want when the controller is in the maximum position.
NOTE: Make sure you store any changes you want to save before moving on.
To Next Page
Loading...
