Design of the AT Wizard M5
The AT Wizard M5 has 3 buttons. On the top side is the power button.When
this button is pressed for approx. 1 second, the device switches on. A further
press of approx. 6 seconds will swicth the device off again.
By pressing the menu key, you can select the functions.These are:
Zero → Set Display to 0
INT → Switching between 1/1 or 1/10 degree or mm
Angle → Switching between angle and travel
Chord → Enter the depth oft he flap in mm to convert angle to travel
Pressing the select key selects the respective function.
To Next Page
Loading...