Global link table of parameters to continuous controllers (P2CC)
ll parameters in the DSP256 are assigned a parameter number. This number is
used as an offset into the P2CC table. The value of an entry in the P2CC may
be 0 through 129. 0 - 127 correspond to continuous controllers 0 - 127. 128
is Channel Pressure and 129 is NotLinked. The following table lists the
DSP256 parameter number assignments and shows the correspondence between a
byte in the P2CC and a DSP256 parameter.
1 Not Used
2 Flange Delay
3 Flange LFO Speed
4 Flange LFO Depth
5 Flange Feedback
6 Flange EQ Source
7 Mix:Flange R Lvl
8 Mix:Flange L Lvl
9 Chorus Delay
10 Chorus LFO Speed
11 Chorus LFO Depth
12 Chorus EQ Source
13 Mix:Chorus R Lvl
14 Mix:Chorus L Lvl
15 Mix:Dry Level
16 Delay Time
17 Delay Feedback
18 Delay In:Dry
19 Delay In:Flange
20 Delay In:EQ
21 Delay EQ Source
22 Mix:Delay R Levl
23 Mix:Delay L Levl
24 Not Used
To Next Page
Loading...
