NOTE:
• The test may take more time for large capacitors to charge, wait until
the readings settle before removing the leads.
• To improve the accuracy of measurement less than 10nF, subtract the
residual capacitance of the meter and test leads.
TEMPERATURE MEASUREMENT
WARNING:
To avoid electrical shock, do not perform temperature measurement when
the input voltage exceeds 36VDC or 36VAC RMS.
1. Set the rotary switch to °C / °F position, LCD displays values of
environmental temperature.
2. Insert the temperature probe into the input jack, insert red plug of
thermo probe into V °C/°F jack, black plug of thermo probe into COM
jack, making sure to observe the correct polarity.
3. Place the temperature probe head onto the part you wish to measure,
keeping the probe touching the surface until the reading stabilises.
4. Read the temperature in the LCD display.
FREQUENCY MEASUREMENT
WARNING:
To avoid electric shock, do not apply more than 250VDC or 250VAC RMS
before taking frequency measurement.
1. Set the rotary switch to desired frequency range.
2. Insert the black text lead banana plug into the negative COM jack and
the red test lead banana plug into the positive Hz jack.
3. Touch the test lead tips to the circuit under test.
4. Read the frequency value in the LCD display.
INDUCTANCE MEASUREMENT
1. Set the rotary switch to desired inductance range.
2. Insert the black test lead banana plug into the negative COM jack and
the red test lead banana plug into the positive ma LX jack.
3. Touch the test lead tips to the circuit under test.
4. Read the inductance value in the LCD display.
DISPLAY BACKLIGHT
Press the button for 1 or 2 seconds to turn on or off the display
backlight function, the backlight will automatically turn off after 10
seconds.
To Next Page
Loading...