Photo/Name card Holder
USB cable
4: Loading Slides
Hold up the slide toward the light. Face the trademark side of the slide away
from you. Look through the slide and it should appear normally (not a mirror
image).
Now turn the slide so the image is upside down while looking at the same side.
Open the slide holder at the marked spot on the top.
With the slide holder laid open place the slide into recessed area in the holder-
the slide should fit perfectly.
Note: Handle slides with care. Any dust scratches or fingerprints
will show up
on your saved images. You’d better to cotton gloves when handling slides. It is
recommended to use compressed air to remove any dust on the slides. You
can purchase it from an office supply or electronics retailer.
Close the slide holder and press the edges so that it locks in place.
Hold it in the position as shown in the film & photo scanner.
4 - EN
To Next Page
Loading...
