© 2022 Digitrax, Inc. www.digitrax.com— 3 —
-
tion indicated on just the status LEDS.
-
This provides initial verication that your PM74 working on LocoNet.
You are now ready to customize your track wiring as detailed in the
next sections.
2.0 Best Practice DS Short Circuit protection:
1.
2. -
double gap pairs
occur on either rails and feeders connected to DS1.
3. all the rails and feeder wiring to a
short-circuit during installation. The e.g. DS1 relay will click repeatedly
4.
DS1, e.g. a box car with a resistor wheel set. The status led L1 will light
that DS1 is occupied and a transponder has been detected. The decoder
address and DS location is reported onto LocoNet.
To Next Page
Loading...