Need help?Do you have a question about the Digitus professional DN-170089 and is the answer not in the manual?
General| Emergency Power Off (EPO) | Yes |
|---|---|
| Rack Capacity | 2U |
| Height | 88 mm |
| Operating Temperature (T-T) | 0 - 40 °C |
| Storage Temperature (T-T) | -15 - 45 °C |
| Audible Alarm(s) | Yes |
| Safety | EN 62040-1 |
| Electromagnetic Compatibility (EMC) | EN 62040-2 |
| Nominal Output Voltage | 230 V |
| Nominal Input Voltage | 230 V |
| Battery Technology | Sealed Lead Acid (SLA/VRLA) |
| Typical Backup Time at Full Load | 3 min |
| Form Factor | Rackmount |
| Alarm Modes | Low battery, overload, fault |
| Output Voltage | 230V |
| Output Waveform | Sinusoidal |
| Communication Interface | USB |
| Safety Certifications | CE |
The UPS contains LETHAL VOLTAGES. All repairs and service should be performed by AUTHORIZED SERVICE PERSONNEL ONLY.
The UPS contains its own energy source (batteries). The UPS output may carry live voltage even when the UPS is not connected to an AC supply.
Batteries can cause a risk of electrical shock or burn from high short-circuit current. Observe proper precautions.
Description of the UPS control cover, including buttons, LCD, and indicator LEDs.
Procedures for setting bypass function and configuring the output voltage of the UPS.
Procedures for starting the UPS in line mode or using DC without mains power, including self-test.
Detailed explanation of the EPO function, its activation, and related safety warnings and precautions.
Safety precautions and steps for replacing batteries, including specific procedures for OnLine UPS battery packs.
To Next Page
