Digitus DA-20311 - Page 5

5
4. Adjust the stand
legs then tighten
the screw knob
5. Loosen the screw
knobs on the
middle pole and the
top pole
6. Pull the poles up
to the height
(max2.1m) you
want and tighten
the knobs
7. Install the Mobile
Phone Clip on the
Head Ball and
tighten it as the
arrow direction
shows
8. Loosen the
screws at the
bottom and leave
some gaps for
installation on the
ring light
9. Mount the
assembled mobile
phone holder on
the ring of the Ring
light
10. Press the clamp
with your fingers
and rotate to tight
11. Install the Head
Ball on the ring light
and rotate to tight
12. Install the
mounted Head Ball
on the tripod and
rotate it tight
13. Assembly completed