Unit Set-Up
The Receiver must be synchronised to suit your individual Controller.
1. Remove the front facias from both the Controller and Receiver units.
(see ‘Installation’).
2. Ensure both the Controller and Receiver(s) are powered up. To
activate the Controller press the standby button see ‘1’ in Fig. 2.
When activated, the ‘ON’ (Green) light will illuminate.
3. Press the ‘TRANSMIT’ button on the Receiver. The Receiver goes
into synchronise mode. This is indicated by both the ‘AUTO’ (yellow)
and the ‘HEAT’ (Red) lights flashing. If more than one Receiver is to
be controlled by a single Controller all Receivers must similarly be put
into synchronise mode. Each Receiver will remain in synchronise
mode for approximately one minute.
4. With the Receiver(s) in the synchronise mode the ‘TRANSMIT’ button
on the Controller is then pressed. This puts the Controller in
synchronise mode, this is indicated by the Controller ‘HEAT’ (red)
and ‘BOOST’ (blue) lights flashing. The Controller will remain in
synchronise mode for approximately ten seconds.
5. The Receiver will automatically go into auto mode once a signal has
been received from the Controller. The Controller is ready once the
‘AUTO’ (yellow) light is lit on the Receiver.
6. The front facias should then be replaced on both the Controller and
Receiver, ensuring the bottom screw is replaced.
Operating Instructions
Please refer to ‘RF Controller Unit Instructions’.
Cleaning
WARNING: ALWAYS PLACE THE CONTROLLER IN STAND BY MODE
BEFORE CLEANING.
Do not use detergents, abrasive cleaning powders or polish of any kind
on the controller.
Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean
off stains. Be careful not to allow moisture into the heater.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not be
disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for
recycling advice in your country.
After sales service
Should you require after sales service or should you need to purchase
any spares, please contact the retailer from whom the appliance was
purchased. Please do not return a faulty product to us in the first instance
as this may result in loss or damage and delay in providing you with a
satisfactory service. Please retain your receipt as proof of purchase.
To Previous Page
Loading...