OPERATOR’S MANUAL with Maintenance Information
Function Tests
22
1 Select a test area that is firm, level and
free of obstruction.
At the Ground Controls
2 Pull out the platform red Emergency Stop
button to the on position.
3 Turn the red Emergency Stop button
clockwise to the on position.
4 Turn the key switch to ground control.
5 0bserve the diagnostic LED readout on the
ground controls.
⊙ Result: The LED readout will come on and
display SYSTEM READY.
6 Start the engine. See Operating
Instructions section.
Test Emergency Stop
7 Push in the ground red Emergency Stop
button to the off position.
⊙ Result: The engine should turn off and no
functions should operate.
8 Turn the red Emergency Stop button
clockwise to the on position and restart the
engine.
Test Up/Down Functions and
Function Enable
A buzzer with different sound frequency is
controlled in central system. The descent
alarm sounds at 60 beeps per minute. The
alarm that goes off when the machine is not
level sounds at 150 beeps per minute. An
optional automotive-style horn is also
available.
9 Do not press the lift function enable button.
Press and hold the platform up/down
button.
⊙ Result: No function should operate.
10 Press and hold the lift function enable
button. Press and hold the platform up
button.
⊙ Result: The platform should rise.
11 Press and hold the lift function enable
button. Press and hold the platform down
button.
⊙ Result: The platform should lower then
stop at the height is 3.5m. The descent
alarm should sound while the platform is
lowering.
12 Press and hold the lift function enable
button. Press and hold the platform down
button.
⊙ Result: The platform should lower to end.
The descent alarm should sound while the
platform is lowering.
Test the Auxiliary Lowering
13 Activate the up function and raise the
platform approximately 60 cm.
14 Press the engine start/ flameout button to
engine off.
15 Press and hold the lift function enable
button. Press and hold the platform down
button.
⊙ Result: The platform should lower.
16 Turn the key switch to platform control and
restart the engine.
At the Platform Controls
Test Emergency Stop
17 Push in the platform red Emergency Stop
button to the off position.
⊙ Result: No functions should operate.
18 Pull the red Emergency Stop button out to
the on position.
⊙ Result: The LED readout will come on and
display SYSTEM READY
To Next Page
Loading...
