SANITIZE FLOOR SURFACES
1. Vacuum floors before
sanitizing.
3. Use steam alone on your
Steam+Clean, Do not use
cleaning solution.
2. Plug in then press the power
switch on your Steam+Clean.
The steam light will turn
green when it's ready.
4. With cleaning pad attached, run
a minimum of 4 strokes at a
medium pace (5-7 seconds per
32" stroke) across same area.
Allow to air dry.
WARNING
Never leave the Steam Mop in one spot on any surface for
an extended period of time with a damp or wet cleaning
pad attached as this may damage the floor surface.
CAUTION
IMPORTANT
Cleaning pad and mop head may be hot.
Do not store unit with a damp or wet
microfiber cleaning pad attached.
POWER
HOW TO
711
To Next Page
Loading...
