TO TURN THE STEAM CLEANER ON
Make sure your Steam Cleaner is unplugged.
Detach the water container.
Unscrew the cap
fi-om the water container. Fill
water container with warm tap water. Tighten securely.
USE TAP WATER
or
DISTILLED WATER ONLY. DO NOT OVEWILL THE WATER
CONTAINER.
Replace cap and fasten the water container to main body until it
locks into place.
Place desired Attachment on Steam Cleaner by inserting into nozzle cap and
rotating to the locked position.
Plug Steam Cleaner Power Cord into any standard
3
prong grounded outlet.
Power on the Steam Switch. Power Indicator Light will go on when the heater is
heating.
Allow approximately
30
seconds for Steam Cleaner for pre-heating.
The Pilot
Light will go off when the heater is ready.
Turn on the steam by pressing the Steam Trigger as needed.
Begin using Steam Cleaner by pointing Attachment at areas you want to clean,
pressing the Steam Trigger to activate steam while loosening dirt and grime with a
back and forth motion, directing the steam as necessary.
Simply brush steamed areas clean when using Brush attachment.
TO TURN THE STEAM CLEANER OFF
Turn the Steam Cleaner off by releasing the Steam Trigger and then unplugging
the Power Cord from the power outlet.
The unit will take ten minutes to cool down.
Empty excess water from the water container.
Then, store in a cool, dry place.
REMEMBER TO LET THE STEAM CLEANER
COOL FOR
10
MINUTES BEFORE CHANGING ANY ATTACHMENTS
Page
5
To Next Page
Loading...