Contents-5
CONTENTS
1-3-3. Cleaning the spindle main body.........................................................G-30
1-3-4. Cleaning the edge of the spindle........................................................G-31
1-3-5. Completion of spindle cleaning ..........................................................G-32
FYI: Possible problems of the spindle due to stains .....................................G-32
2. Maintenance and Inspection to Be Done Every Day...........................G-33
2-1. Maintenance and Inspection Before Turning ON the Power........................G-34
2-2. Maintenance and Inspection After Turning ON the Power ...........................G-35
3. Maintenance to Be Performed at 7-Day
(Recommended) Intervals..................................................................G-36
3-1. Cleaning the Cutting Room..........................................................................G-37
3-1-1. Water case outer area cleaning..........................................................G-38
3-1-2. Water case inside cleaning ................................................................G-40
3-1-3. Completion of cleaning the cutting room............................................G-41
4. Maintenance to Be Performed at 30-Day
(Recommended) Intervals..................................................................G-42
4-1. Conditioning the Flange...............................................................................G-42
5. Maintenance to Be Performed at 90-Day
(Recommended) Intervals..................................................................G-43
5-1. Cleaning the Electrical box Filter
(in case this machine is used outside the cleanroom)..................................G-44
6. Maintenance to Be Performed at 183-Day
(Recommended) Intervals..................................................................G-49
6-1. Conditioning the Wheel Mount.....................................................................G-49
6-2. Greasing the Axes and Ball-Bearing Leadscrews........................................G-50
6-2-1. Greasing the X-axis............................................................................G-51
6-2-1-1. Cleaning the rail and ball-bearing leadscrew .....................................................G-52
6-2-1-2. Greasing the left side of the X-axis.....................................................................G-54
6-2-1-3. Greasing the right side of the X-axis ..................................................................G-56
6-2-1-4. Completion of greasing the X-axis......................................................................G-58
6-2-2. Greasing the Y-axis............................................................................G-59
6-2-2-1. Greasing the rear of the Y-axis...........................................................................G-60
6-2-2-2. Greasing the front of the Y-axis ..........................................................................G-63
6-2-2-3. Completion of greasing the Y-axis......................................................................G-66
6-2-3. Greasing the Z-axis............................................................................G-67
6-2-3-1. Greasing the Z-axis ............................................................................................G-68
6-2-3-2. Completion of greasing the Z-axis......................................................................G-71
To Next Page
Loading...
