EasyManua.ls Logo

Dish Network Wireless Joey Access Point User Manual

Dish Network Wireless Joey Access Point
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Wireless Joey
Access Point
INSTALLATION GUIDE
REGULATORY INFORMATION
FEDERAL COMMUNICATIONS COMMISSION NOTIFICATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Do not make changes or modifications to this equipment. This could void the users
authority to operate the equipment.
Product must be installed at least 20 cm (~8 inches) from typical person locations per FCC
RF exposure regulations.
Operation of Wi-Fi on channels 5150-5250 MHz is restricted to indoor use only.
If none of the remedies stops the radio interference, you should contact a licensed radio/
television technician, your satellite dealer, or call the Customer Service Center at 1-800-333-
DISH (3474), for assistance.
Copyright © 2014. EchoStar Technologies L.L.C., Englewood,
Colorado 80112. All rights reserved. DISH is a registered trademark
of DISH Network L.L.C. Other products, brands, and companies
mentioned are the Trademarks of their respective owner(s). This
product is designed in the United States and manufactured in India.
WELCOME
Thank you for buying the Wireless Joey Access Point. The Wireless
Joey Access Point transmits the WiFi video signals from the Hopper to the
Wireless (WiFi) Joey. Please follow these instructions to connect your new
Wireless Joey Access Point. You can also visit http://mydish.com for additional
information on home networking.
PACKAGE CONTENTS:
Wireless Joey
Access Point
Power
WiFi signal
Ethernet
WPS
Power Supply
Installation Guide
For all your customer needs, go to
mydish.com/chat or call the
Customer Service Center at
1-800-333-DISH (3474)
Ethernet Cable
(10 foot cable)
Question and Answer IconNeed help?

Do you have a question about the Dish Network Wireless Joey Access Point and is the answer not in the manual?

Dish Network Wireless Joey Access Point Specifications

General IconGeneral
CategoryTV Receiver
TypeWireless Access Point
ConnectivityWireless
Wireless Standard802.11ac
Ethernet Ports1
Wireless Frequency2.4 GHz
PurposeExtend Dish Network service to additional TVs wirelessly
CompatibilityDish Hopper System (Hopper 3, Hopper Duo, Hopper, Hopper w/Sling, Hopper 2000)

Summary

WELCOME

SETUP AND INSTALLATION

USING YOUR WIRELESS JOEY ACCESS POINT WITH YOUR HOPPER ® RECEIVER AND WIRELESS JOEY TM

Decide where to place your Wireless Joey Access Point in your house and connect it to your Hopper receiver.

INSTALLATION CONFIGURATIONS

Server-side Configuration #1

Connects the Wireless Joey Access Point to the Hopper receiver on the server side.

Server-side Configuration #2

Alternative server-side connection method for the Wireless Joey Access Point and Hopper.

Client-side Configuration

Configuration for the Wireless Joey Access Point when used on the client side.

QUICK TROUBLESHOOTING TIPS

CONSIDERATIONS

REGULATORY INFORMATION

FEDERAL COMMUNICATIONS COMMISSION NOTIFICATION

Details compliance with FCC rules and guidelines for the Wireless Joey Access Point.

Related product manuals