Displays2go Glass Display Case IFDC8040 - User Manual

1. Place the base (A) on the ground, insert the front glass panel (B) and 1 side glass panel (C) into grooves in the base.
Hold glass panels in place and connect them with edge bracket (G) and corner bracket (H) by using screws (J). Tighten
screws with a flat-head screw driver. Do the same for the opposite side.
CAUTION:
Be careful when handling glass!
A
PARTS LIST
A. Base
B. Glass Panel - Front
C. Glass Panel - Side
D. Glass Panel - Door
E. Glass Panel - Shelf
F. Glass panel - Top
G. Edge Bracket
H. Corner Bracket
I. Shelf Peg & Rubber Ring
J. Screw with Clear Washer
K. Aluminum Bar
L. “L” Metal Bracket
M. Door Hinge
N. Door Lock with Key
O. Glass Seal
X1
X1
X2
X2
X4
X1
X2
X2
X16
X28
X1
X2
X4
X1
X1
TOOLS NEEDED
- Flat-head Screwdriver
- Phillips Screwdriver
IMPORTANT SAFETY INFORMATION:
Read all instructions before start installing the unit. Displays2go is not responsible for any damage or injury
caused by incorrect installation, assembly or use. 3 people are recommemded for assembling.
B
C D
E
F
NOTE: Extra hardware is common.
I
J
G
H
K
Unpack the base box and remove parts attached inside the base (A).
Remove glass panels from the crate and identify all glass panels.
N
M
L
O
ASSEMBLY INSTRUCTIONS
Ver. 11/18
IFDC8040 - Glass Display Case - Double Door
1 of 3

Displays2go Glass Display Case IFDC8040 Specifications