v
English
FAQs
The most common questions – answered at a glance
1. Telekom Speedport Smart 3
Problem: Device cannot be logged in. The router should have the rmware
update (status 9/2019): 010137.3.5.000.1 or newer!
2. Change distybox
300
settings
Normally, it is absolutely sufcient if you use distybox
300
in your router or
the DECT base station. No further parameters need to be changed, it does
not matter whether you use VOIP phone or fax, book in and you‘re done.
There are only a few exceptions that require parameter changes.
3. Can the distybox
300
also be operadet with a VOIP port?
The type of mains connection is not relevant for the operation of distybox
300
.
It works on all networks.
4. No analog phone at hand?
You no longer have an analogue telephone to set parameters of distybox
300
?
No problem: You can set all the dialing procedures via the the keyboard of your
multifunction device.
5. Fax is not transmitted or not
transmitted completely!
Everything is set up correctly, but incoming or
outgoing faxes are not or only incompletely
transmitted?
Please reduce the transmission speed of your
fax machine (baud rate) as much as possible.
distybox
300
www.disty.de
09/2019
To Next Page
Need help?
General
