126 FX30 - SPECIFICATIONS
500
126 FX30 - SPECIFICATIONS
500
Engine U.S. Metric
Engine: Kubota D1105-ES diesel
Cooling medium antifreeze, see
MAINTENANCE for more
information
Injection
1991 lbf/in
2
140 kgf/cm
2
Number of cylinders 3
Displacement
68.6 in
3
1123 cm
3
Bore 3.07 in 7.70 cm
Stroke 3.09 in 7.86 cm
*Maximum tilt angle fore & aft 30° 30°
*Maximum tilt angle side 30° 30°
Engine manufacturer's gross power rating
@ 3150 rpm
26 hp 19.4 kW
Maximum governed speed as installed (no
load)
3160 rpm 3160 rpm
Flywheel power (full load) 22 hp 16.4 kW
Hydraulic tilt system U.S. Metric
Pressure 2500 psi 172 bar
Drive type 12 volt DC power
Cylinder size (2) 3 in 76 mm
Maximum tilt angle 45° 45°
Time to tilt fully up 44 sec 44 sec
Time to tilt fully down 38 sec 38 sec
Battery: SAE cold crank @ 0°F (-18°C) 800 amp, 12 volt
Noise Levels
Operator 73 dBA sound pressure per ISO 6394, at operator ear 10 ft (3
m) behind vacuum tank.
Exterior 103 dBA sound power per ISO 6393, at vacuum relief.
*Exceeding these operating angles will cause engine damage. This DOES NOT
IMPLY machine is stable to maximum angle of safe engine operation.
Engine U.S. Metric
Engine: Kubota D1105-ES diesel
Cooling medium antifreeze, see
MAINTENANCE for more
information
Injection
1991 lbf/in
2
140 kgf/cm
2
Number of cylinders 3
Displacement
68.6 in
3
1123 cm
3
Bore 3.07 in 7.70 cm
Stroke 3.09 in 7.86 cm
*Maximum tilt angle fore & aft 30° 30°
*Maximum tilt angle side 30° 30°
Engine manufacturer's gross power rating
@ 3150 rpm
26 hp 19.4 kW
Maximum governed speed as installed (no
load)
3160 rpm 3160 rpm
Flywheel power (full load) 22 hp 16.4 kW
Hydraulic tilt system U.S. Metric
Pressure 2500 psi 172 bar
Drive type 12 volt DC power
Cylinder size (2) 3 in 76 mm
Maximum tilt angle 45° 45°
Time to tilt fully up 44 sec 44 sec
Time to tilt fully down 38 sec 38 sec
Battery: SAE cold crank @ 0°F (-18°C) 800 amp, 12 volt
Noise Levels
Operator 73 dBA sound pressure per ISO 6394, at operator ear 10 ft (3
m) behind vacuum tank.
Exterior 103 dBA sound power per ISO 6393, at vacuum relief.
*Exceeding these operating angles will cause engine damage. This DOES NOT
IMPLY machine is stable to maximum angle of safe engine operation.
To Next Page
Loading...
