Ditch Witch FX30 - Pothole

FX30 - OPERATION 67
POTHOLE
FX30 - OPERATION 67
POTHOLE
POTHOLE
1. Ensure that unit is hitched to vehicle or properly stabilized.
Block the wheels.
2. Remove vacuum hoses from storage.
If using 1200:
• Disconnect hose from
hose catch.
• Insert hose through rollers
(2).
• Pull vacuum hose reel
control (1) down to unwind
hose.
• Disconnect hose end (3)
from hose reel.
3. Remove 2-in-1 potholing tool or basic potholing tool from
storage.
4. Connect hoses. Secure locking clamps on inlet valve and
potholing tool.
IMPORTANT: Inlet valve can be open or closed before
starting engine. If valve is closed, vacuum will build faster.
5. Ensure that drain valve is closed.
6. If using 2-in-1 potholing tool,
connect water pressure hose
to fitting as shown.
om0658h.eps
1
2
3
POTHOLE
1. Ensure that unit is hitched to vehicle or properly stabilized.
Block the wheels.
2. Remove vacuum hoses from storage.
If using 1200:
• Disconnect hose from
hose catch.
• Insert hose through rollers
(2).
• Pull vacuum hose reel
control (1) down to unwind
hose.
• Disconnect hose end (3)
from hose reel.
3. Remove 2-in-1 potholing tool or basic potholing tool from
storage.
4. Connect hoses. Secure locking clamps on inlet valve and
potholing tool.
IMPORTANT: Inlet valve can be open or closed before
starting engine. If valve is closed, vacuum will build faster.
5. Ensure that drain valve is closed.
6. If using 2-in-1 potholing tool,
connect water pressure hose
to fitting as shown.
om0658h.eps
1
2
3