EasyManua.ls Logo

Ditch Witch JT920L - Page 86

Ditch Witch JT920L
169 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
86 JT920/JT920L - SETUP
86 JT920/JT920L - SETUP
Engage EZ-Connect
1. Apply tool joint compound to threads and align hole in EZ-
Connect collar with tapped hole in EZ-Connect box.
2. Slide collar onto octagonal barrel and push toward wrench
flats.
3. Thread tool head EZ-Connect pin into EZ-Connect box until
shoulders are touching.
4. Back tool head off one flat and slide collar onto pin until
retainer bolt hole is visible.
5. Install retainer bolt and tighten.
Engage EZ-Connect
1. Apply tool joint compound to threads and align hole in EZ-
Connect collar with tapped hole in EZ-Connect box.
2. Slide collar onto octagonal barrel and push toward wrench
flats.
3. Thread tool head EZ-Connect pin into EZ-Connect box until
shoulders are touching.
4. Back tool head off one flat and slide collar onto pin until
retainer bolt hole is visible.
5. Install retainer bolt and tighten.

Table of Contents

Related product manuals