©2010 Diversey, Inc., 8310 16th Street, Sturtevant, WI 53177-1964
LIT30096 (10/133)
www.diversey.com
Pump is not moving/
spinning/rotating
1. Is the bail down?
The pump will only operate when the bail is in the
down position
User should verify that the bail is in the
down position
2. Is the TrailBlazer being pulled in the proper direction?
The pump with only move with the bail in the down
position and when the TrailBlazer is pulled in the proper
direction
User should verify that the bail is in the down position
and the unit is being pulled in the proper direction.
3. Is the pump cable tight?
The pump cable (similar to a bicycle brake cable) can
become loose during shipping, installation or after
continued use.
User should tighten the pump cable by following
the proper procedures in the user manual or cable
repair video.
Pump is moving/spinning/
rotating but it is making a
clicking noise
1. Is the pump cable tight?
The pump cable (similar to a bicycle brake cable) can
become loose during shipping, installation or after
continued use.
User should tighten the pump cable by following
the proper procedures in the user manual or cable
repair video.
Pump is moving but no nish
is coming out of the manifold
1. Is the white tap on the oor nish BIB (bag-in-box)
turned on?
For nish to ow out of the BIB the white tap needs to be
in the on position
User should turn the white tap on the BIB to the on
position (towards the baseplate)
2. Are the feed lines connected properly?
The feed lines need to be connected to the proper pump
inlet & outlet to allow nish to ow
User should verify that the long feed line connector
is attached to the pump inlet on the open side of the
TrailBlazer and the short feed line is connected from
the manifold to the pump outlet on the closed side
of the TrailBlazer.
3. Is the internal pump tube stuck?
The internal pump tube can get stuck during long
periods of storage.
User should remove the pump, then use ngers
to break any part of the white internal pump tube
that appears stuck. See instruction manual for
detailed information.
Finish is puddling/pooling
at the end of passes
1. Is the bail being moved up early enough?
When nearing the end of each pass with the TrailBlazer
the bail should be moved to the up position to eliminate
excess nish from puddling/pooling up at the end of
each pass.
User should move the bail to the up position no later
than 10’ before the end of each pass and as early as 15'.
User should also use the clean up tool to cleanup the
excess nish.
2. How much of each nish pass being overlapped?
It is recommended to only overlap each pass by 3", if
more overlapping is occurring it will cause increased
nish on the side of the overlap potentially causing
puddling/pooling of nish.
User should operate the TrailBlazer only overlapping
each nish pass by no more than 3".
User should also use the clean up tool to cleanup the
excess nish.
TrailBlazer Troubleshooting
TrailBlazer®
To Next Page
Need help?
General
