dji AGRAS MG-1 - Remote Controller LED

22
© 2016 DJI All Rights Reserved.
AGRAS MG-1 User Manual
Optimal Transmission Range
Optimal Transmission Range
Strong Weak
The signal transmission between the aircraft and the remote controller performs best when the
aircraft is within the optimal transmission range. Open up the antennas on the remote controller to
optimize transmission range. Ideally, the at surface of the antenna should be facing the aircraft. If
the signal is weak, y the aircraft closer to you.
Remote Controller LED
RTH Status LED
Status LED
The Status LED indicates the connection status between the remote controller and the aircraft. The
RTH Status LED indicates the Return-to-Home status of the aircraft. See the table below for details
on these indicators.
Status LED Sound Remote Controller Status
— Solid Red chime
The remote controller is not connected to
the aircraft.
— Solid Green chime
The remote controller is connected to the
aircraft.
Blinks Red 1 slow beep repeating Remote controller error.
RTH Status LED Sound Aircraft Status
— Solid White chime Return-to-Home procedure is initiated.
Blinks White 1 beep repeating
Sending Return-to-Home command to the
aircraft.
Blinks White 2 beeps repeating The aircraft is returning to the Home Point.