dji AGRAS MG-1 - Regaining Control and Battery Warnings

© 2016 DJI All Rights Reserved.
33
AGRAS MG-1 User Manual
5 Go Home (15m can be set)
Blinking Blue
1 Record Home Point (HP)
Blinking Purple
3 Remote Controller Signal Lost
Blinking Blue
2 Conrm Home Point
Blinking Purple 5 Times
6 Landing after Hovering 15secs
Blinking Blue
4 Signal Lost Lasts 3secs
Blinking Blue
Height over HP>15m
Elevate to 15m
Height over HP<=15m
15m
<8m
GPS≥7
When the GPS count is less than 6 or GPS is not working, the aircraft can only stabilize
the attitude without returning to the Home Point.
Start RTH by pressing and holding the RTH button in emergency situations. DO NOT
power off the remote controller to start RTH.
Make sure there are no obstacles during RTH procedure and you are familiar with how to
regain control of the aircraft.
How to Regain Control
The table below shows ways to regain control during the Failsafe RTH procedure. To regain control
during the Smart RTH procedure, refer to the “Positioning” and “Attitude” Flight Mode sections in
the table below.
Flight Mode Switch
Flight Mode Positioning Attitude Manual
Regain Control
Toggle the Flight Mode Switch once to regain
control if the signal recovers.
Regain control as
soon as the signal
recovers.
Low Battery Level Warnings
There are two low battery level warnings:
1. Low battery level warning: the Aircraft Status Indicator blinks yellow. Fly the aircraft back and
land it as soon as possible, then stop the motors and replace the batteries.
2. Critically low battery level warning: the Aircraft Status Indicator blinks red. The aircraft will begin
to descend and land automatically. You can change the settings in MG-1 Assistant so that the
aircraft does not automatically descend and land when the Aircraft Status Indicator LED blinks
red.
The threshold of the two low battery levels can be set in the MG-1 Assistant.
RTH Illustrator