dji AGRAS T10 - Executing Operations; Performing an Operation

* Any obstacles in or out of the operation area can be marked.
Once you have finished planning, press the back button on the remote controller to return to the home screen.
●The calibration points are used to offset the bias of the flight route caused by the positioning difference. Choose at least one existing
landmark as the fixed reference point for calibration when executing the same operation. If none are available, use an easily
identifiable object such as a metal stake.
Performing an Operation
Walk with the remote controller
alongside the boundary of the
operation area and tap Add
Waypoint C2 at turning points.
Walk to each
obstacle in turn
and tap Obstacle
Mode C1.*
Walk around the obstacle
and tap Add Obstacle C2
at several points around
the obstacle.*
Tap Waypoint C1 to return
to add edge points to the
operation area.
Walk to the location
of each calibration
point and tap
Calibration Point.
The waypoints and flight route can be
edited. Fine-tune waypoint positions,
configure distance and line spacing, and
adjust the route direction by tapping or
dragging the icon .
Save the
field
plan.
Take the aircraft to
one of the calibration
points.
Tap Execute Task in the
home screen of the
app.
Tap and select the
field from the field list.
Tap Edit to edit the
waypoints and flight
route again.
Tap Use and tap Rectify
Offset.
Tap Start.
Set operation
parameters
and confirm.
Set the auto-takeoff height and move the
slider to take off. The aircraft will perform
the operation automatically.