EasyManua.ls Logo

dji AIR 3 Fly More Combo - Charging the Battery

dji AIR 3 Fly More Combo
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DJI Air 3
User Manual
62
  
©
2023 DJI All Rights Reserved.
The battery level LEDs display the power level of the battery during discharging. The
statuses of the LEDs are dened below:
 : LED is on      : LED is ashing      :
LED is o
LED1 LED2 LED3 LED4 Battery Level
88%-100%
76%-87%
63%-75%
51%-62%
38%-50%
26%-37%
13%-25%
0%-12%
Powering On/O
Press the power button once and then press again and hold for two seconds to power the
battery on or o. The battery level LEDs display the battery level when the battery is powered
on. The battery level LEDs turn o when the battery is powered o.
Low Temperature Notice
1. Battery capacity is signicantly reduced when ying at low temperatures from -10° to C
(14° to 41° F). It is recommended to hover the aircraft in place for a while to heat the battery.
Make sure to fully charge the battery before takeo.
2. Batteries cannot be used in extremely low-temperature environments of lower than -10° C (14° F).
3. When in low-temperature environments, end the ight as soon as DJI Fly displays the low
battery level warning.
4. To ensure optimal performance, keep the battery temperature above 20° C (68° F).
5. The reduced battery capacity in low-temperature environments reduces the wind speed
resistance performance of the aircraft. Fly with caution.
6. Take extra caution when ying at a high elevation with a low temperature.
Charging the Battery
Fully charge the battery before each use. It is recommended to use the charging devices
provided by DJI, such as the DJI Air 3 Battery Charging Hub, DJI 100W USB-C Power Adapter, DJI
65W Portable Charger, or other USB Power Delivery chargers. Visit the ocial DJI online store
for more information about DJI ocial charging devices.
Using a Charger
1. Connect a charger to an AC power supply (100-240V, 50/60 Hz; use a power cable with
suitable specications for charging, and use a power adapter if necessary).
2. Connect the aircraft to the charger using the battery charging cable with the battery powered o.
3. The battery level LEDs display the current battery level during charging.

Table of Contents

Related product manuals