dji D12000iE - Initial Installation; Removing the Original Supporting Feet; Installing the Supporting Feet; Installing the Casters

4
EN
Installing the Supporting Feet
Align the mounting holes on the supporting feet with those on the generator frame. Insert the bolts through the
mounting holes and secure them with nuts.
1. Bolt
2. Supporting Foot
3. Nut
1 2 3
Installing the Casters
Place the washer on the inner side of the mounting holes on the generator frame, insert the wheel shaft
through the caster and the mounting holes, and secure with the clip.
1. Wheel Shaft
2. Washer
3. Clip
1 2 3
Installing the Handles
Align the handle with the mounting holes on the generator frame, insert the bolt throught the mounting holes,
and secure with a nut.
1. Bolt
2. Nut
3. Handle
1
2
3
Initial Installation
Removing the Original Supporting Feet
To install the casters and the matching supporting feet, remove the four original supporting feet rst.
1. Nut
2. Original Supporting Foot
3. Bolt
1
2
3