dji D12000iEP - Status Indicator Lights; Understanding LED Status Indicators

EN
EN
7
Status LEDs
1. Charging Channel Status LED
2. DC Module Status LED
3. Generator (excl. DC Module)/AC Module Status LED
4. USB-C Connector Cover
Status LED Blinking Pattern Description
Charging Channel
Status LED
Solid yellow Battery connected and ready for charging
Blinks green once continuously Charging
Solid green Fully charged
Blinks yellow once continuously Warning for the battery/charging channel
Blinks red once continuously Battery/charging channel error
DC Module Status
LED
Blink yellow four times continuously DC module is not activated
Blinks yellow once continuously Warning for the DC module
Blinks red once continuously DC module error
Generator (excl. DC
Module)/AC Module
Status LED
Blink yellow four times continuously
Generator (excl. DC Module)/AC Module is not
activated
Blinks yellow once continuously
Warning for the generator (excl. DC Module)/AC
Module
Blinks red once continuously Generator (excl. DC Module)/AC Module error
Blinks red four times continuously Generator (excl. DC Module) maintenance is required
• When the status LEDs blink indicating a warning or error, connect the USB-C connector of
the generator to the USB-A connector of the remote controller using a USB-C cable. Run the
DJI AGRAS™ app on the remote controller and check the specific warnings or errors on the
charging device interface.
• When the status LED blinks prompting for maintenance, connect the USB-C connector of
the generator to the USB-A connector of the remote controller using a USB-C cable. Run the
DJI Agras app on the remote controller and check the specific maintenance information on
the charging device interface. When maintenance is finished, press the reset button on the
charging device interface to turn off the status LED blinking for maintenance.
• If any part of the generator is abnormal or damaged, it is recommended to contact a DJI-
authorized dealer or DJI Support to repair or replace the part.
1
2
3
4
USB-C Cable
USB-C Connector on the Generator USB-A Connector on the Remote
Controller