©
2020 DJI All Rights Reserved.
35
MATRICE 300 RTK User Manual
Installing the Batteries
Pairing Batteries
Before rst use, it is recommended to mark 2 batteries as a pair and continue using them as a pair (charge
and discharge them together) to maximize service life and ensure ight performance. If two batteries
with a signicant dierence in battery life are installed and powered on, a prompt will pop up in the app
to recommend that you replace the batteries to a pair with similar performance.
Replacing the Batteries When Turned On
If the battery needs to be replaced immediately after landing, you can replace it without turning off
the aircraft. Replace with one fully charged battery, and wait for 3 seconds, and then replace another
battery.
Heating the Battery
Manual Heating: If the Intelligent Flight Battery is not installed into the aircraft, press and hold the
battery level button on the battery for four seconds to initiate the self-heating, keeping the batteries at a
temperature between 61° F (16° C) and 68° F (20° C), which is the ideal range of operating temperature,
for approximately 30 minutes. Press and hold the battery level button for two seconds to stop heating.
Auto Heating: Insert the batteries into the aircraft and power it on. If a low battery temperature is
detected, the battery will automatically heat up to maintain a temperature between 61° F (16° C) and
68° F (20° C).
The battery level LEDs will blink as follows when the battery is warming up and keeping warm.
Turning On / O
The battery can only be turned on and off after it is installed on the
aircraft.
Turning On: Press the Power button once, then press again and hold for 3
seconds to turn on. The Power LED will turn green and the Battery Level
Indicators will display the current battery level.
Turning Off: Press the Power button once, then press again and hold for 3
seconds to turn o. The Power LED and the Battery Level Indicators will be o.
Warming up Keeping warm
To Next Page
Loading...
