72
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
indicated by a dierent color. When the battery level is lower than the warning threshold, the battery
icon on the right turns red, reminding the user to land the aircraft as soon as possible and replace
the batteries.
5. GNSS Positioning Status: displays the number of GNSS satellites. When the aircraft RTK module is
disabled, the RTK icon will turn gray; when it is enabled, the RTK icon will turn white. Tap the GNSS
positioning status icon to view the status of the RTK mode and GNSS positioning.
6. Signal Strength: includes HD video link quality and remote controller link quality. Three green dots
indicate strong signals; two yellow dots for medium signal strength; and one red dot for poor signal
quality. If the signal is lost, the icon will display a disconnected status in red.
7. Intelligent Flight Battery Level: displays the remaining battery level of the aircraft. Tap to view battery
level, voltage and temperature information.
8. Settings: Tap to expand the settings menu to set the parameters of each module.
a. Flight Control System Settings: include ight mode switch, Home Point, return to home
altitude, maximum altitude, distance limit, sensor status, out-of-control action, coordinated
turn, and GNSS.
b. Sensing System Settings: include obstacle sensing switch, vision positioning switch,
and precision landing switch.
c. Remote Controller Settings: include stick mode, customizable button settings, and
remote controller calibration and linking.
d. Video Transmission Settings: include work frequency, channel mode, and video output
type.
e. Intelligent Flight Battery Settings: include battery information, smart return-to-home, low
battery warning thresholds, and number of days required for self-discharge.
f. Gimbal Settings: include gimbal pitch and pan settings, and gimbal auto calibration.
g. RTK Settings: include the RTK positioning function, maintain positioning accuracy
mode, RTK service type, and their corresponding settings and status displays.
h. General Settings: include map selection, track display, unit setting, and lights setting.
AR Projection
DJI Pilot 2 App supports AR projection, including:
a. Home Point: When the Home Point is beyond the current view, it will be displayed on the edge of the
view. The aircraft can be turned towards the Home Point by following the arrow.
b. PinPoints: A PinPoint appears bigger when near the aircraft and smaller when it is far. This allows
users to judge the distance between the PinPoint and the aircraft from the size of the PinPoint. When
a PinPoint selected is beyond the current view, it will be displayed on the edge of the view. The
aircraft can be turned towards the PinPoint by following the arrow.
c. Waypoints: In a mission ight, the two waypoints the aircraft is about to reach will be projected on
FPV camera view or gimbal camera view. The next waypoint to be reached will appear as a solid
triangle and a serial number; while the subsequent waypoint will appear as a dotted triangle and a
serial number.
d. ADS-B Manned Airplane: When a manned airplane is detected close by, it will be projected on FPV
camera view and gimbal camera view. Ascend or descend the aircraft as soon as possible to avoid
the manned airplane by following the prompted instructions.
To Next Page
Loading...
