dji MATRICE 300 RTK - Page 97

©
2020 DJI All Rights Reserved.
97
MATRICE 300 RTK User Manual
Buffer Zone
Buer Zones for Restricted Zones/Authorization Zones: To prevent the aircraft from accidentally ying
into a Restricted or Authorization Zone, the GEO system creates a buffer zone of about 20 meters
wide outside each Restricted and Authorization Zone. As shown in the illustration below, the aircraft
can only take o and land in place or y toward an opposite direction of the Restricted or Authorization
Zone when inside the buer zone, and cannot y toward the Restricted or Authorization Zone unless an
unlocking request has been approved.
The aircraft cannot y back into the buffer zone after leaving
the buffer zone.
Buer Zones for Altitude Zones: A buer zone of about 20 meters wide is established outside each
Altitude Zone. As shown in the illustration below, when approaching the buer zone of an Altitude Zone
in a horizontal direction, the aircraft will gradually reduce its ight speed and hover outside the buer
zone. When approaching the buer zone from underneath in a vertical direction, the aircraft can ascend
and descend in altitude or y in an opposite direction of the Altitude Zone, but cannot y toward the
Altitude Zone.
The aircraft cannot y back into the buffer zone in a horizontal direction after leaving
the buffer zone.
Ground
Restricted Zone/
Authorized Zone
Ground
Buffer Zone
Altitude Zone
Altitude Limit
20 m
20 m
20 m
20 m