©
2016 DJI All Rights Reserved.
7
MATRICE 600
User Manual
3. Insert the frame arm into the arm connector on the center frame with the propeller away from the
center frame. Rotate the frame arm to align the screw holes on the frame arm and connector. Then
insert and tighten four M3×6.5 screws.
4. Pull the cables of the frame arm through the arm stopper and insert the stopper into the arm
connector.
5. Pull the cables through the cable outlet and cable xing ring on the lower plate of the center frame.
Arm Stopper
Lower Plate of the Center Frame
Cable Outlet
Cable Fixing Ring
2. Remove the lower cover of the center frame for installation and connection.
6. Gently lift the frame arm. Twist the red knob to lock each arm in place. Be sure you hear an audible
click, which indicates a proper lock. Check the arm for movement. To store, untwist the knob and
lower the frame arm.
To Next Page
Loading...
