dji O3 Air Unit - Activation; Firmware Update; Linking

8
©
2022 DJI All Rights Reserved.
DJI O3 Air Unit
User Manual
Activation
Connect the air unit to a computer using the USB-C port, and run DJI Assistant 2 (Consumer Drones
Series) for activation.
Make sure to activate the device before using for the rst time. Otherwise, some functions will be
unavailable:
If the air unit is not activated, its transmission power will be limited (≤25 mW), and the menu
screen of the connected goggles cannot be operated.
If the goggles are not activated, only linking is available and the menu screen cannot be
operated. Additionally, the device will also be set in the public channel and cannot be set to
other channels after linking. Note that the public channel is easily prone to interference from
other transmission devices.
Firmware Update
Use DJI Assistant 2 (Consumer Drones Series) to update the air unit, the goggles, and the remote
controller separately.
1. Power on the device and connect it to a computer with a USB-C cable.
2. Launch DJI Assistant 2 and log in with a registered DJI account.
3. Select the device and click “Firmware Update” on the left side of the screen.
4. Select the rmware version.
5. DJI Assistant 2 will download and update the rmware automatically.
6. Restart each device after the rmware updates are complete.
Make sure that the device has sufcient power before updating rmware.
Linking
Make sure that all devices have been updated to the latest rmware versions before linking.
The air unit must be linked to the goggles before the remote controller.