1
EN
Safety at a Glance
By using this product, you signify that you have read, understand,
and accept the terms and conditions of this guideline and all
instructions at www.dji.com/power-500. EXCEPT AS EXPRESSLY
PROVIDED IN AFTER-SALES SERVICE POLICIES AVAILABLE AT
HTTPS://WWW.DJI.COM/SERVICE/POLICY, THE PRODUCT AND ALL
MATERIALS AND CONTENT AVAILABLE THROUGH THE PRODUCT
ARE PROVIDED "AS IS" AND ON "AS AVAILABLE BASIS" WITHOUT
WARRANTY OR CONDITION OF ANY KIND. This product is not
intended for children.
Safety Instructions
• Make sure this power station product is grounded effectively and reliably
before charging. An AC power cable with a grounding conductor and
a grounding plug is provided. Use the provided cable and connect an
outlet that is properly installed and grounded in accordance with all local
laws and regulations. Improper connection of the equipment grounding
conductor may result in an electric shock.
• To avoid the risk of fire, electric shock, or injury to persons, DO NOT
disassemble or modify the power station.
• The electrolytes in the power station are highly corrosive. If any
electrolytes come into contact with your skin or eyes, immediately wash
the affected area with water and seek medical support.
• DO NOT place fingers or hands into the power station.
• Keep the power station out of reach of children and pets.
• DO NOT disassemble or pierce the power station in any way. Otherwise,
the power station may leak, catch fire, or explode.
• If the power station falls into water, make sure to take anti-electric shock
measures before touching the power station, then take it out immediately
and place it in a safe and open area. Stay away from the power station
until it is completely dry. DO NOT use the power station again. Dispose of
the power station according to local regulations.
• DO NOT use components or accessories that are not recommended by
DJI
TM
. Contact DJI Support if any component or accessory needs to be
repaired or replaced. DJI takes no responsibility for any damage caused
by components or accessories that are not recommended.
• DO NOT use damaged batteries. In such situations, contact DJI Support.
• DO NOT insert a bare cable or other metal objects into the ports of the
power station. Otherwise, the power station will be short-circuited.
• DO NOT use the power station with damaged cables.
• When not in use, remove the AC cable and all connected devices. To
reduce the risk of damage to the electric plug and cord, pull the plug
rather than the cord.
• DO NOT allow the power station to come into contact with any kind of
liquid. DO NOT leave the power station out in the rain or near a source of
moisture.
• DO NOT leave the power station near heat sources such as a furnace or
heater or inside a vehicle on hot days. If the power station catches fire,
use sand or a dry powder fire extinguisher to put out the fire.
• DO NOT put the power station in a microwave oven or a pressurized
container.
• DO NOT use the power station in strong electrostatic (e.g., thunderstorms)
or electromagnetic environments.
• DO NOT use a battery if it is involved in a crash or heavy impact.
• Make sure to use the power station in a well-ventilated environment. DO
NOT block the heat dissipation vents of the power station. Otherwise, the
power station may be damaged by excessive heating and may even lead
to a fire hazard.
• Make sure to use the power station at the specified operating
temperature. Using the power station at high temperatures will lead to a
fire or explosion. Using the power station at low temperatures will reduce
the battery performance.
• This product is not recommended for powering medical emergency
equipment related to personal safety, including but not limited to
medical grade ventilators (hospital version CPAP, Continuous Positive
Airway Pressure) and artificial lungs (ECMO, Extracorporeal Membrane
Oxygenation). Follow the doctor’s instructions and contact the
manufacturer for restrictions on using such equipment. If used for
general medical equipment, make sure to monitor the power status and
ensure that the power does not run out.
• The power station will generate electromagnetic fields when in use,
which are likely to affect the operation of medical implants or personal
medical equipment such as pacemakers, cochlear implants, hearing aids,
defibrillators, etc. If these types of medical equipment are being used,
contact the manufacturer for restrictions on using such equipment. Make
sure to keep a safe distance between the medical implants and the power
station.
• If the power station is connected to a refrigerator, power fluctuations may
cause the power station to automatically shut down. When connecting
the power station to a refrigerator that stores medicine, vaccines, or
other valuable items, it is recommended to press and hold the AC output
button. This helps provide a continuous power supply to the refrigerator.
Make sure to monitor the power status and ensure that the power does
not run out.
Storage and Transportation
• The power station cannot be carried onto a plane. Please comply with
local regulations of civil aviation transportation.
• DO NOT place the power station near explosive or hazardous material or
near metal objects such as eyeglasses, watches, jewelry, and hairpins.
• It is recommended to transport the power station with the original
product packaging. Make sure to power off and disconnect the power
station from other devices during transportation.
• DO NOT attempt to transport a damaged battery or a battery with a
power level higher than 30%.
• If the power station needs to be stored for a long time, it is recommended
to discharge the power station to 60%. Storing with a high power level will
shorten the battery life. Storing with a low power level may lead to over-
discharge.
• The power station should be stored in a cool and dry environment without
direct sunlight at the specified storage temperature. DO NOT place the
power station in water or where water may leak.
Maintenance
• DO NOT store the power station for an extended period after fully
discharging. Otherwise, the battery may over-discharge and cause
irreparable damage to the battery cell.
• For long-term storage, put the product in a storage bag. Charge and
discharge the power station once every four months to ensure the battery
performance: discharge the power station to 15%, power off for more
than two hours, and then charge it to 100% in 270W standard recharge
mode.
• Clean the ports with a clean, dry cloth if there is any noticeable buildup.
DO NOT clean the power station with alcohol or other flammable
solvents.
Battery Disposal
• The power station contains hazardous chemicals, make sure to strictly
follow local regulations regarding the disposal and recycling of batteries.
DO NOT dispose of the power station in a regular waste disposal
container.
• Dispose of the power station in a suitable recycling container only after
fully discharging it.
• Power stations that are over-discharged, swollen, involved in a crash,
come into contact with liquid, damaged, or leaky must be disposed of
properly. DO NOT use any power station in such a condition in order
to avoid damage or injury. Contact a professional battery disposal or
recycling agent for further assistance.
Specifications
General
Model DYM500L/DYM500H
Capacity 512 Wh
Dimensions 305×207×177 mm (L×W×H)
Output Ports
AC Output
[1]
(×2) DYM500L:
NA: 120 V AC, 50/60 Hz, 800 W (rated), 1000 W (max.
continuous output)
JP: 100 V AC, 50/60 Hz, 800 W (rated), 1000 W (max.
continuous output)
DYM500H: 800 W (rated), 1000 W (max. continuous
output)
CN: 220 V AC, 50/60 Hz
EU: 230 V AC, 50/60 Hz
UK: 230 V AC, 50/60 Hz
AU: 230 V AC, 50/60 Hz
To Next Page
Loading...
