5. Preparing the Gel Beads
Soak the gel beads to the size with a diameter of 5.9 - 6.8 mm. It is recommended
to use pure water, and it will take around 4 hours to finish soaking.
The average load of the gel bead container is around 430 beads. Soak the
appropriate number of gel beads according to actual usage.
A. Fill the gel bead container with the soaked gel
beads.
B. Make sure to clean the remaining water in the
container.
The size of the soaked gel beads may vary when using different types of water.
Make sure to soak the gel beads to the specific size to avoid block the launcher.
6. Preparing the Robot
Installing the Gel Bead Container Removing the Gel Bead Container
Installing and Powering On the Intelligent Battery
Insert the Intelligent Battery, and then press and hold the power button to power
it on.
To Next Page
Loading...
